Does your vibration program use order-based setups?
Frequency can be defined as how often an event occurs per unit of time. A vibration spectrum is displayed as a horizontal and vertical plot (X and Y). The horizontal (X) axis is the frequency axis and shows a representation of how often an event occurs. Typically, the vibration analyst may use multiple units of reference for the frequency axis when doing vibration analysis. The most common units used for the spectrum (FFT) are cycles per minute (CPM) and Hertz. The least known unit for the spectrum frequency axis is “Orders” or multiples of shaft turning speed. It is critical to understand the differences in the frequency units (Hz, CPM and Orders). It can be advantageous to view data in different units depending upon the machine and problem being analyzed.
Orders are ratios of frequencies to multiples of a shafts turning speed. For example, a 60 Hz motor turning 1780 RPM would also have a rotational speed of 29.66 Hz. The rotational speed would be referenced as one (1) order. Two (2) orders would be twice the shaft turning speed (59.33 Hz) and so on.
Certain equipment defects occur based upon some multiple of turning speed. Looking at data based upon order references can make it easier to remember the specific defect frequencies and identify them during routine analysis.
Order-based analysis is a good way to set up and ensure that the correct frequency range is being monitored for variable speed machines, etc. You can define your analysis setups in orders and be ensured that the correct frequency ranges will be measured by your vibration data collector as the speed of the machine changes over time.
Most modern vibration analysis software and vibration data collectors support order-based data collection and analysis. If you are unsure, then you should consult the provider of your vibration software and hardware and find out.
Tip provided by: LUDECA, Inc.
Previous tip: Time Waveform Analysis Tools
Next tip: Calculation of Unknown Bearing Types in your Equipment
« Back to all maintenance tips
Have your say
- R300S for When Good Enough – Isn’t Enough!
- Join The Association For Maintenance Professionals
- Belt/Sheave Alignment Laser, Custom Shim and Gaskets
- Reliability Engineering Services
- Motor Testing Books
- Total Productive Maintenance Books
- Job Postings for Maintenance and Reliability Professionals
- New AT33IND Perfect for QC & Troubleshooting
- MRO Inventory and Purchasing Books
- IR Windows: Compare and Save with Exiscan
- Request Your Des-Case Complimentary Breather Now
- Commtest - Affordable Vibration Analysis
- GPAllied Inspired Training: Hard-Hitting, Impactful Courses and Workshops.
- Reliability Centered Maintenance for SAP Plant Maintenance
- February 28
Motor Electrical Predictive Maintenance and Testing Training - March 19
RCM-2012 Reliability-Centered Maintenance and Root Cause Analysis Conference - April 17
Enterprise Asset Management (EAM) and Computerized Maintenance Management System (CMMS) Summit - April 24
Asset Operations Excellence Master Class and the Manufacturing Game - May 1
Focused Change Management for Reliability Initiatives and the Reliability Game - May 15
AM-2012 Asset Management Forum - June 5
CBM-2012 Condition Monitoring and Predictive Maintenance Forum - July 23
Infrared Level I Certification Course - October 3
Maintenance Strategy Master Class Level 1 - October 9
Focused Change Management for Reliability Initiatives and the Reliability Game
Comments
There are no comments for this article yet. Why not add one?